Mahr Digimar 817 CLM - Page 143

143
Mahr GmbH • Digimar 817 CLM
Description / Sequence Symbols / Pictures
If batteries are fully discharged, completely recharging them takes
approximately 5 hours. The charging device can be connected for a
longer period without any risk, since an intelligent switching circuit
prevents overcharging. The batteries can be charged even if the height
measuring instrument is switched off.
Exchanging the batteries
– Separate the charging device from the height measuring instrument
– Remove the battery cover, by unscrewing the 2 knurled thumb
screws, ill. 1
– Loosen the clip for the RJ-plug and carefully pull out, ill. 2
– Remove the battery pack out off the retaining spring (clips), ill. 3
– Press the new battery pack into the retaining spring and reconnect
the plug to the battery pack, ill. 4
– Replace the battery cover and insert and tighten the knurled thumb
screws
– Attach the new battery pack to the mains adapter and charger for a
min. 5 hours.
Attention
Please only use the specified battery pack!
1
2
3
4