Mahr Digimar 817 CLM - Page 47

47
Mahr GmbH • Digimar 817 CLM
Description / Sequence Symbols / Pictures
0
– Press the „Zero point“ key
– Press the „Preset“ key
– Use the cursor to select characteristics 2.
– Confirm by pressing the function key characteristic
– Use the keypad to enter the actual size.
– Press the „Preset“ key
– Confirm by pressing the ON/OFF key
– To check, move the holder upwards and confirm by pressing the
bore center key.
⇒ The measuring range has been expanded by 174 mm.
PR
ON
OFF
PR
A
2