Manitowoc 2250 - Section 1; Crane Data; Crane;Attachment Identification; Tier 4 F Engine

Reference Only
Manitowoc Published 06-24-16, Control # 241-01 1-1
2250 OPERATOR MANUAL INTRODUCTION
1
SECTION 1
INTRODUCTION
CRANE DATA
See the crane data specific to your crane:
• Basic specifications
• EC declaration (if applicable)
CRANE/ATTACHMENT IDENTIFICATION
See Figure 1-1 for the following.
An identification plate is attached to the outside of the
operator’s cab and to the available attachments (for
example, luffing jibs, Ringers, and MAX-ERs).
The crane or attachment model, application, and serial
number are provided on the plate.
For the exact location of the identification plates on your
crane and attachments, see the Nameplates and Decals
Drawing in this manual.
TIER 4F ENGINE
This manual applies only to 2250 cranes equipped with a
Tier 4F engine.
CHANGE OF OWNERSHIP REGISTRATION
If you are the new owner of a Manitowoc crane, please
register it with Manitowoc Cranes so we can contact you if
the need arises.
1. Go to www.manitowoccranes.com.
2. Go to Service > Manitowoc Crane Care > Service
Information > Change of Ownership Form
3. Complete the form.
CRANE ORIENTATION
The terms RIGHT, LEFT, FRONT, and REAR refer to the
operator’s right, left, front, and rear sides when seated in the
operator’s cab looking forward.
• The boom is on the front of the rotating bed.
• The crawler drive shafts are at the rear of the crawlers
and carbody.
FIGURE 1-1
Serial
Number
Model
Number