Manitowoc 2250 - Remove Rotating Bed from Trailer

Reference Only
Manitowoc Published 06-24-16, Control # 241-01 4-13
2250 OPERATOR MANUAL SETUP AND INSTALLATION
4
Remove Rotating Bed from Trailer
NOTE: The circled numbers in Figure 4-7 correspond to
the numbers of the following steps.
1. Rotate four jacks to the operating position (see also
Figure 4-8
) and pin the struts to the jacks.
2. Remove the jack pads from storage (Figure 4-7
, View B)
and fasten them to the jacks (see View E).
3. Pin the rear alignment pendants to the lugs on the
rotating bed (Figure 4-7
, View F).
4. Start the engine and extend the jacks with the controls
on the jacking remote to lift the rotating bed to clear the
trailer.
5. Remove the tie-down strap between the lugs on the
operator’s cab frame and the rotating bed. Unclamp and
swing the operator’s cab to the intermediate position
(Figure 4-9
, View A).
6. Fully extend the jacks to lift the rotating bed off the trailer
(Figure 4-7
, View C).
7. Remove the trailer (Figure 4-7
, View C).
8. Unlatch and open the doors covering the upper
hydraulic disconnect (Figure 4-7
, View D).