OPERATING CONTROLS AND PROCEDURES 2250 OPERATOR MANUAL
3-32
Published 06-24-16, Control # 241-01
Load Indicator
See the RCL Manual for operating instructions.
Mast Up Limit
For the MAX-ER 2000, this limit automatically stops the mast
when it is raised to 80° in Standard mode (MAX-ER mode
OFF). This limit is provided to stop the mast when it is used
as a boom during assembly and disassembly.
To bypass the limit when raising the mast to its operating
position, switch to Standard Setup mode (MAX-ER mode
OFF).
SEAT CONTROLS
WARNING
Overload Hazard!
Avoid serious injury or equipment damage. Never
overload the capacity of the crane. A crane load indicator
is installed on the crane to aid the operator.
The presence of the load indicator on the crane in no way
substitutes for or lessens the requirement that the
operator’s knowledge, experience, and judgment are
required to ensure safe operation of the crane.
Before using the load indicator, the operator shall verify
that it is properly calibrated. See the instructions in the
RCL Manual.
WARNING
Falling Mast Hazard!
Avoid serious injury or equipment damage. To prevent the
mast from falling over backward, make sure the proper
size hold-back is used when raising the mast to its
operating position. Do not raise the mast above 80°
except when raising the mast to its operating position.
See the MAX-ER Operator Manual for detailed mast
raising and lowering instructions.
Armrest (unzip cover to expose screw
at rear of each armrest)—
Turn the screws to raise and lower the
armrests to the desired position.
Armrests can be rotated up when not
needed.
Backrest—
Rotate the knob to raise and lower the
backrest to the desired position.
Seat Height—
Push release lever to the left to unlock.
Using body pressure, raise and lower
the seat to desired position. Release the lever
and make sure it is latched.
Seat and Console Fore and Aft
(adjusts seat and consoles)—
Push release lever to the left to unlock.
Using body pressure, slide the seat and
consoles forward or rearward to the desired
position. Release the lever and make sure
it is latched.
Seat Fore and Aft (adjusts seat only)—
Push release lever to the left to unlock.
Using body pressure, slide seat
forward or rearward to desired
position. Release lever and make sure
it is latched.
CAUTION
Avoid Damage!
Disconnect the electric cord from the
rear of the right console before
removing the seat from the
operator’s cab.
A794
FIGURE 3-13
To Next Page
Loading...
