SET-UP AND INSTALLATION TMS9000-2 OPERATOR MANUAL
6-24
Published 02-21-2019, Control # 611-05
Extending/retracting the lifting cylinders
This section describes how to operate the lifting cylinders
manually,
- for correcting the displayed rigging mode and
- for pre-charging the counterweight afterwards.
NOTE: Always lift and lower the counterweight in
automatic mode, otherwise swinging with extended
lifting cylinders will be blocked, refer to Automatic
mode rigging, page 6-25, Automatic mode
unrigging, page 6-26.
Correct the rigging mode
You can use the automatic mode only if the current rigging
mode is displayed (Figure 6-30).
Support Condition
On Tires 0% Retracted
57%
Mid 1-Extended
79%
Mid 2 -Extended
100%
Full- Extended
No Counterweight
Rotation not
permitted
Rotation
permitted
Rotation permitted
6,000 lb
8,000 lb
11,000 lb
Rotation not
permitted
16,000 lb
21,000 lb
26,000 lb
36,000 lb
48,500 lb
WARNING
Tip-over Hazard!
Use the table to check whether sufficient outrigger span is
set for the rigged counterweight or the free-standing truck
crane, before you unlock and rotate the superstructure.
Only rotate the superstructure if the truck crane is
sufficiently stabilized. This prevents the truck crane from
overturning during rotating because of too much or too
less counterweight mass.
CAUTION
Machine Damage!
With the override switch actuated, the functions are
always enabled.
Swing the superstructure only when the lifting cylinders
are fully retracted.
A Counterweight rigged
B Counterweight unrigged
FIGURE 6-30
9200-2
9200-1
A
B
To Next Page
Loading...
