SET-UP AND INSTALLATION TMS9000-2 OPERATOR MANUAL
6-26
Published 02-21-2019, Control # 611-05
• To swing, move the control lever in the displayed
direction (1, Figure 6-35) or (2) – the automatic mode
continues.
- The superstructure turns into position (C).
- The lifting cylinders are retracted (D).
- The counterweight is pre-charged – symbol (3)
green.
• Release the control lever.
Automatic mode unrigging
While the automatic mode is being executed, you can always
- Cancel the automatic mode, refer to Cancel
automatic mode, page 6-27.
- interrupt the automatic mode by letting go of the
control lever. After moving the lever in the displayed
direction once more, the automatic mode is
continued.
Prerequisites
- The lifting cylinders must be fully retracted – symbol
(3, Figure 6-36) green.
- The swing gear must be switched on – symbol (1)
green.
- The superstructure must be in the rigging range:
- Symbol (4) active,
- Symbol (2) displayed.
FIGURE 6-34
8851-11a
1
2
3
9200-2
To Next Page
Loading...
