Manitowoc Grove TMS9000-2 Series - Page 361

GROVE 6-25
TMS9000-2 OPERATOR MANUAL SET-UP AND INSTALLATION
6
Published 02-21-2019, Control # 611-05
If necessary, correct the displayed rigging mode as follows:
• Swing the superstructure out of the rigging range so that
the lifting cylinders can be freely extended.
Assuming the symbol (4, Figure 6-31) is yellow with the
counterweight unrigged.
• Press the override button (3).
• Fully extend the lifting cylinders – symbol (1).
• Release the override button (3).
• Fully retract the lifting cylinders – button (2).
The symbols (4) become green.
You can now use the automatic mode.
Pre-tensioning
When the symbol (3, Figure 6-32) is red, you must pre-
tension the counterweight.
• Select and confirm the symbol (1) until the symbol (2)
becomes green.
Automatic mode rigging
While the automatic mode is being executed, you can always
- Cancel the automatic mode, refer to Cancel
automatic mode, page 6-27.
- interrupt the automatic mode by letting go of the
control lever. After moving the lever in the displayed
direction once more, the automatic mode is
continued.
Prerequisites
- The counterweight combination must be
assembled.
- The lifting cylinders must be fully retracted – symbol
(4, Figure 6-33) green.
- The swing gear must be switched on – symbol (1)
green.
- The superstructure must be in the rigging range:
- Symbol (3) active,
- Symbol (2) displayed.
Switch on automatic mode
• Select and confirm the symbol (3, Figure 6-34).
Execute the automatic mode
• To swing, move the control lever in the displayed
direction (1) or (2) – the automatic mode starts.
- The superstructure turns into position (A).
- The lifting cylinders are extended (B).
• Release the control lever.
FIGURE 6-31
8851-8a
1
2
3
4
FIGURE 6-32
9200-1
32
1
FIGURE 6-33
9200-5
3
1
2
4
4