Operation
161
5
Operation Using Single Acting Remote Hydraulic Cylinders
IMPORTANT: Single acting remote circuits cannot
be used for continuous oil supply applications.
When using single acting hydraulic cylinders
connect the hose (from hte single acting cylinder) to
the bottom remote coupler.
By moving the relevant lever/joystick control to the
raised position the single acting cylinder will
extend.
Move the lever/joystick control back to neutral to
stop the cylinder. If the cylinder reaches full
extension the lever/joystick control will
automatically return to the neutral position.
Move the lever/joystick control to the float position
to retract the cylinder. This allows up to 9 litres of
hydraulic oil to be dumped to the transmission at
minimum back pressure.
MH04N02
WARNING: When remote
cylinders are connected to the
hydraulic system, cycle the
control lever about three times
to remove air from the cylinder
and hoses. With air in the
system raised equipment can
drop accidentally and cause
personal injury or machine
damage.
To Next Page
