Routine Maintenance
230
Change Planetaries Oil
(Non-Braked Axle)
STEP 1
MD02C081
Park the tractor on level ground and turn each
hub until the plug (1) is at the bottom.
STEP 2
Put a suitable size container under the plug.
Remove the plug. For best results drain the oil
when the oil is warm (after operation).
STEP 3
After the oil has drained, turn each wheel hub
until the plug is at the 3 or 9 o'clock position. Add
the recommended oil type until the oil is level
with the bottom edge of the plug hole. Wait
approximately 5 minutes for the oil to settle, then
check the oil level again and add oil if necessary.
STEP 4
Install the plug and tighten.
IMPORTANT:
Dispose of oil and filters in
accordance with local regulations. DO NOT
drain the oil on the ground, into a drain or put
in a container that can leak. Be responsible for
the environment.
Check Condition of Fuel Injectors
The fuel injectors must not be cleaned. New
injectors must be fitted by your dealer if there is
damage or a fault occurs as listed below:
● Engine will not start or is difficult to start.
● Not enough power.
● Engine misfires or runs erratically.
● High fuel consumption.
● Black exhaust smoke.
● Engine knocks or vibration.
● Excessive engine temperature.
Check Engine Valves
Have your dealer check the engine valve to
tappet clearances.
1000 HOUR MAIN SERVICE
1
To Next Page
Loading...
