Instruments and Programming
72
Cab Suspension Calibration (Menu 6)
Although the McCormick Cab Suspension system
is calibrated when leaving the factory, it will be
necessary to re-calibrate if the cab or any of the
suspension components are removed. Also if any
of the linkages are adjusted or if the control module
is replaced.
STEP 1
Start the engine.
IMPORTANT: Keep all person’s clear of the
tractor prior to entering the calibration mode
and starting the engine.
STEP 2
The cab suspension will raise to the upper limit,
and then lower to the lower limit. It will then
repeat before stopping at the calibrated "mid"
point.
Calibration is now complete.
Momentarily press the menu button
to enter the calibration mode.
To Next Page
Loading...
