MCCORMICK MTX Series - Page 87

Instruments and Programming
79
4
STEP 4
*NOTE: Even though the MTX series does not
have a 750 rpm PTO option a zero (0) must be
programmed into the cluster. This informs the
cluster that this option is not available and
therefore the cluster will not display any
information for that option.
STEP 5
Programming A True Ground
Speed Sensor (Radar) Constant
(Menu 8)
If a true ground speed radar is installed via the
factory a constant will have been programmed
into the cluster. However if a McCormick radar is
installed as a dealer option it will be necessary to
programme the cluster.
IMPORTANT: Although these constants can be
viewed by the operator, the operator must NOT
change any of the current values as this may
affect the correct operation of the tractor. If
however it is necessary to change the
constants the following procedure should only
be carried out by your dealer.
STEP 1
STEP 2
STEP 3
Use the UP and Down buttons to input
the new constants.
Refer to the following table for the
correct constants to input into the
cluster.
Model
540
PTO
750
PTO *
1000
PTO
European Specification 82 0 52
American Specification 94
Momentarily press the menu button to
store the new constant and return to
the main menu.
Momentarily press the menu button
to enter the menu.
Use the UP and Down buttons to input
the constant, 4150.
Momentarily press the menu button to
store the constant and return to the
main menu.