Instruments and Programming
78
Programming the “OLd”
Instrument Cluster Hours
(Menu 6)
The cluster hourmeter display reading can not be
changed. A new cluster will always start
recording at ‘0”. If a new cluster is installed, the
recorded hours from the old cluster can be
programmed into a separate ‘OLd hour display in
the new cluster. This function provides the option
to store and display the hours recorded by a
replaced cluster, so an accurate recording of the
tractors total hours can be kept electronically.
STEP 1
STEP 2
STEP 3
Programming the PTO Constants
(ALL PTO options) (Menu 7)
IMPORTANT: Although these constants can be
viewed by the operator, the operator must NOT
change any of the current values as this may
affect the correct operation of the tractor. If
however it is necessary to change the
constants the following procedure should only
be carried out by your dealer.
STEP 1
STEP 2
STEP 3
Momentarily press the menu button.
Use the UP and Down buttons to input
the old cluster engine hours
accordingly.
Momentarily press the menu button to
store the old hours and return to the
main menu.
Momentarily press the menu button
to enter the menu.
Use the UP and Down buttons to
scroll through the menus until you
reach the required PTO constant to
change.
Once the correct PTO option has
been found Momentarily press the
menu button. This allows you to enter
the menu and change the constant.
The current constant will be shown
under the icon and directly under that
will be the new constant to be
programmed.
To Next Page
Loading...
