Microplex SOLID F44 - A-3.6 Macro Control Commands

Appendix A Programming Guide
A-18
A-3.6 Macro Control Commands
MACRO CONTROL COMMANDS Description
ESC & f # Y Macro ID
ESC & f # X Macro Control
# = 0 : Start macro definition (last ID specified)
# = 1 : Stop macro definition
# = 2 : Execute macro (last ID specified)
# = 3 : Call macro (last ID specified)
# = 4 : Enable macro for automatic
overlay (last ID specified)
# = 5 : Disable automatic overlay
# = 6 : Delete all macros
# = 7 : Delete all temporary macros
# = 8 : Delete macro (last ID specified)
# = 9 : Make macro temporary (last ID specified)
# = 10 : Make macro permanent (last ID specified)
Note: For detailed information see HP PCL 5 Technical Reference Manual .