Beschreibung der einzelnen Menüpunkte
4-6
PAPER EXTENDED
With PAPER EXTENDED set to NO printing into the border areas of A4 and
LETTER pages is not possible which is in line with the PCL5 definition. However,
for compatibility to existing applications which use the border areas PAPER
EXTENDED can be set to YES. Now the entire physical page is printable at which
the default cursor position remains unchanged.
With format CUSTOM the complete page can also be printed but the default
cursor position is always the first dot at the upper left corner.
PAPER SELECTION
Selecting the paper format (A4, LETTER, CUSTOM) from the host can be done
with PCL or PJL commands. The execution of these commands can be influenced
by the parameter PAPER SELECTION.
RECOGNIZE – A change of PAPER is possible via interface by means of
PCL- or PJL-commands.
ONLY PJL – Only via PJL-command (default)
IGNORE – Any command to change the paper format will be ignored;
the paper format can only be modified via the operator panel.
Note: PAPER SELECTION by the printer driver needs the setting RECOGNIZE
or ONLY PJL.
The F44 pr
inter driver for Windows7 uses PCL and PJL sequences.
.
FUSER TEMP. (Fuser Temperature)
This parameter allows adapting the fuser temperature to media properties.
Default level is MIDDLE (about 200° C).
Other selections are:
─ HIGH (for thick paper, labels, and in conjunction with MICR; about 230° C)
─ LOW (for thin paper and labels; about 170° C)
─ XLOW (for very thin paper and sensitive labels; about 150° C)
Fuser temperature adjustment is necessary when temperature sensitive form sets
(e.g. labels) are printed.
HUMIDITY
Since the paper depending on storage, the moisture takes the environment, with
this parameter; the amount of humidity can be set.
The possible values are:
NORMAL (default)
HIGH
The printer is sensitive to different environmental temperatures. He provides the
best performance however with a temperature of 19 ° to 23 ° C (68 ° to 73 ° F)
with relative humidity 33 up to 47%.
For higher humidity values, the parameter should be set HIGH.
Note: In Chapter 8 Paper Specification there is a detailed description of the
humidity content and storage of the paper.
To Next Page
Loading...
