Microplex SOLID F44 - Hexdump Menu; General Menu

Configuring the Printer
3-9
HEXDUMP MENU
Note: The HEXDUMP MENU will be displayed if the EMULATION in the
GENERAL MENU is set to HEXDUMP
Entry Point = CHANGE PROFILE ---> HEXDUMP MENU
GENERAL MENU
Entry Point = CHANGE PROFILE ---> GENERAL MENU
PARAMETER VALUE
UEL COMMAND
RECOGNIZE *
IGNORE
PARAMETER VALUE
EMULATION PCL *
HEXDUMP
AUTO FORM FEED OFF *
(Range: OFF or 1 up to 120 sec.)
Works only when data in the buffer
.AUTO TEAR OFF 30 sec *
(Range: OFF or 1 up to 120 Sec.)
OFF
TEAR OFF TIME 10 SEC *
(Range: 0 - 120 Sec.)
TEAR OFF SHIFT 0/24 inch *
(Range: -192/24 to +192/24 inch)
PAPER RETRACT
ON *
OFF