Microplex SOLID F44 - Profiler F44; Basic Printer Settings; Test Mode; Printout of Standard Configuration

Configuring the Printer
3-2
–
Profiler F44
The Profiler is software for editing printer profiles of SOLID F44. The contents of the
50 printer profiles (macros) are read from
SOLID F44 and stored on the PC /
notebook. There they can be changed and updated when needed in the printer. The
program requires no installation and has a small memory footprint, so for example it
can be started directly from a USB disk. The profiler requires an active network
connection; the processing of the printer profiles via the parallel port is not possible.
System Requirements: Active network connection to the printer, MS-Windows ®
32bit operating system.
Attention: The printer must be in the ONLINE state when profiles are downloaded
from the PC.
Note: For setting up a network interface, the program InterCon NetTool is
available.
3.1.2 Basic Printer Settings
All parameters which characterise general printer features and functions can be
defined in the menu mode BASIC SETTINGS and the submenu CONFIG.-MENU.
3.1.3 Test Mode
– The TEST MENU allows running of various self tests and configuration print outs.
– The INFO MENU allows the print out of all release information’s of the printer.
3.2 Printout of Standard Configuration
The factory default configuration can be printed within the TEST MENU with the
parameter SELF TEST and is shown on the following page.
The upper part of the SELF TEST printout shows the actual selections and
parameter values.
Main functions appear in the first line of each menu block.
Second and following lines show the selection at sub function level and the selected
parameters behind the "=" sign.
Below the menu section on the test page information is given about the hardware
and software configuration of the printer and stacker is given:
– Memory size (DRAM)
– Bootstrap version
– Available emulations
The rest of the page is filled up with a diagonal test pattern. The black frame around
the test page reflects the actual paper format. The default format is 12 inch for paper
length and 11 inch for image width.