Installing the Printer and the intelligent Paper Stacker
1-15
1.12 Power ON/OFF Switch
– Make sure that the power switch of the printer is placed in the Ο (OFF) (2)
position.
– Connect the printer to the mains using the power cord (1).
Note: With the power ON/OFF switch (2) switches the printer’s power supply and the
Stacker iPS ON or OFF.
When switched ON the printer performs an internal self test which checks the
electronics, fans, and the motors for the paper transport mechanism.
The diplay (3) presents the message:
MEMORY TEST!
PLEASE WAIT...
After successful completion two messages pop up
shortly after each other:
STOP
.............
.............
PCL
Then all fields of the display will show black squares
and a short beep sound; power ON is indicated by a
green LED (4).
In the display appear for a short time the two messages:
O F F L I N E
P C L
Then the display changes to:
READY
The printer is now ready to print, the display shows READY.
Note: if an error message is displayed please refer to section 6.2 Error Messages.
To Next Page
Loading...
