Beschreibung der einzelnen Menüpunkte
4-12
4.3 Menu Mode BASIC SETTINGS
4.3.1 CONFIG. - MENU
In the Configuration Menu general settings for the printer´s operation are defined.
POWER SAVE
The time until the power save mode is entered can be set to 15, 30, 45, 60 MIN or
OFF; factory default is 15 MIN.
– OFF means: the printer doesn´t switch into the POWER SAVE mode.
In power save mode the printer switches off the fuser lamps, the fans, and motors.
Power dissipation in POWER SAVE mode is less than 45 watt. The message
POWER SAVE is displayed. A new print job causes the POWER SAVE mode to be
left.
ALARM BELL
Any error that occurs during a print operation is reported by a corresponding error
message on the display, additionally the buzzer in the operator panel electronics is
activated and the panel LED flashes. The signals can be stopped by either
pressing any key on the panel or by opening the cover. The default setting is ON.
To disable this function set the value to OFF.
Note: The two short signals during power on are always active.
LANGUAGE
Selects the language for the messages that appear on the display of the printer
control panel.
Default is ENGLISH; available are:
ENGLISH, FRANCAIS, and DEUTSCH (German)
MENU ACCESS
The menu CONFIG MENU has been extended by the new function
MENU ACCESS, defining the access rights to various submenus. The access
rights could define being ALL, PROFILE ONLY, or NONE. The locked submenus
aren’t displayed on the panel. However, configuration changes by means of PJL
commands are possible.
A change in the access right can be done via the following sequence of keys on
the control panel:
– Choose the new access right in MENU ACCESS.
– Choose the option and save it with the key (an asterisk * will be set).
– Press the key within the next two seconds.
– Save with the key once more.
Note: A wrong key sequence results in cancelling the current trial and the
complete sequence has to be started again.
To Next Page
Loading...
