Beschreibung der einzelnen Menüpunkte
4-10
TEXT LENGTH
4)
The parameter defines the number of lines on a page; exceeding this limit leads to
a transition onto the next following page. Any value from 0 up to 999 can be
selected; factory default value is 72. The parameter is ignored if PERF. SKIP =
OFF was selected.
PERF. SKIP (PERFORATION SKIP)
4)
In case of PERF. SKIP = ON the printer takes the values of TOP MARGIN and
TEXT LENGTH into account on each page.
If PERF. SKIP = OFF is selected the printer prints over the perforation. At the
transition onto a next following page the values of TOP MARGIN and TEXT
LENGTH are ignored. Factory default selection is OFF.
$$ COMMANDS
This function causes $$ either to be printed as $$ or to program ESC commands
within an application.
If this function is set to ON the characters are interpreted by the printer in the
following way: $$/ means ESC.
4.2.3 HEXDUMP MENU
The HEXDUMP MENU defines the execution of control sequences when the
HEXDUMP mode has been activated.
Note: The HEXDUMP MENU will only be displayed if EMULATION in the GENERAL
MENU is set to HEXDUMP.
UEL COMMAND
Universal Exit Language commands can be set to RECOGNIZE or IGNORE. That
means this code can be executed in HEXDUMP mode or the command is ignored
and printed out as hex code. UEL commands are part of the Printer Job Language
(PJL).
4)
This menu item is only displayed if PAPER size CUSTOM is selected.
To Next Page
Loading...
