Appendix A Programming Guide
A-3
A-1.3 Semi graphics Support under SAP R/3
To increase the printer performance when the printer is running under SAP R/3 PSi
provides a printer specific SAP R/3 device type. These device types make use of the
special semi graphic line draw elements. (see chapter A-4 Support of Semi
graphics for SAP/R3)
The SAP R/3 device type ZPSI3034.PRI including installation description can be
downloaded from the PSi homepage: www.psi-laser.de
A-1.4 EURO Symbol Support
The printer supports printing of the EURO symbol as printer resident character (€)
within the following code tables (see also Appendix B):
– ISO 8859 / 15 LATIN 9
– PC - 858 Multilingual
– SYMBOL
– WINDINGS
Note: The EURO symbol is supported in combination with a restricted number of
printer typefaces.
A-1.5 Support of Logical Pages and Physical Pages
One Physical Page can be spit up into a number of Logical Pages by the parameter
LENGTHFACTOR.
The page length must be configured or programmed according to the physical length
of one page to ensure proper function of the attached stacker. Up to 20 logical pages
can be placed on one physical page. The length limit for an attached stacker
iPS F44 (minimum page length is 7 inch) is only valid for the physical page length.
Two Logical Pages of 6 inch can be printed on physical paper with 12 inch length by
setting LENGTHFACTOR = 2.
The following example shows the PJL commands for an application with image width
= 8.5 inch and a logical page length of 3 inch to be printed on a physical page length
of 12 inch:
ESC%-12345X@PJL SET PAPER = CUSTOM
@PJL SET IMAGEWIDTH = 8.5
@PJL SET PAGELENGTH = 12
@PJL SET LENGTHFACTOR = 4
@PJL ENTER LANGUAGE = PCL
ESC E....PCL file page 1....FF....page 2....FF
....page3....FF ESC E....
To Next Page
Loading...
