Beschreibung der einzelnen Menüpunkte
4-7
TONER DENSITY
This parameter allows adjusting the toner density.
Possible values are:
XHIGH
HIGH
MIDDLE (default)
LOW
XLOW
VER SHIFT (VERTICAL SHIFT)
HOR SHIFT (HORIZONTAL SHIFT)
The parameters VER SHIFT and HOR SHIFT allow to precisely position the print
image vertically (-50...+50/100) and horizontally (!50...+50/100). The adjustment
can be done in steps of 1/100 inch (0.25 mm); factory default value of both
parameters is zero.
INIT LINE REG. (Initial Line Registration)
The conditions inside the printer for feeding of the first pages of a fanfold paper
starting from paper load or paper parking position for paper transportation is
different during continuous printing. If not compensated, it may lead to an
extension of the total line registration tolerance. The function shall be used to
compensate this effect and precisely position the print out even at the very
beginning of a print job.
There are five patterns available. Each pattern contains shift values for 1 up to 5
pages.
Effects of the patterns:
A correction by means of pattern 1 to 5 shifts the print image either to the top or to
the bottom of the used paper.
This shift values apply to a paper length of 11 inch. For page length different to
11 inch the printer automatically adapts the values accordingly.
The INIT LINE REG. parameter can be set to OFF or a pattern from 1 to 5 can be
selected.
How to find the best pattern:
Step 1 Use the parameter VER SHIFT to properly align the line registration for the
10
th
and all following pages.
Step 2 Select and test one of the patterns above for proper alignment of the line
registration for the first pages.
To Next Page
Loading...
