– 2.7 –
Turining the power on
*Be sure to check to ascertain that the pinch rollers have been raised before
turning the power on.
*Turn on the power switch of the device after turning on the power to the host
computer. If the aforementioned order is not correctly followed, the device
can malfunction.
1) Press the “ | ” side of the power switch.
• When the device is turned on, the device will
enter operation modes in the predetermined
order. Refer to page 1.14 for the operation
modes.
2) The POWER indicator lamp lights up in green.
The sheet suction fan rotates.
3) Check the receiving buffer.
Then, the tool conditions for the currently selected tool
appears on the LCD.
CT1 020 050 0.30
BUFFER = 31744KB
BOOT
CG IIc -13F 2.50
Firmware version
To Next Page
Loading...
