– 3.8 –
Switch between remote and the local mode [REMOTE]
Switch between remote and the local mode each time pushing on the [REMOTE] key.
During cut (plot) operation, push on the [REMOTE] to interrupt cutting temporarily. Push on the key
again to restart the cutting operation.
• In a remote mode, push on the jog keys [ ] [ ] to change the cutting (plot-
ting) speed.
The changed cutting (plotting) speed cannot be stored.
Turn off the power supply to return to the toll configuration values.
*[REMOTE] key is effective after detecting a sheet.
* In case temporarily interrupt cut operation, some functions may not be
effective with the error message following below.
In that case, complete the remaining data cutting (plotting), or push on the
[DATA CLEAR] key to execute data clear function. (Refer to Page 3.12 ).
Set the tool configurations [TOOL]
Set the distance compensation and cutting (plotting) configurations.
For details on setting cutting (plotting) configurations refer to Tool conditions setting . (
Page
2.8).
ERR34 DAT RE MAIN
To Next Page
Loading...
