– iii –
Foreword
Congratulations on your purchase of a CG-FX series cutting plotter.
CG-FX series cutting plotter is a highly functional cutting plotter with the high-speed registration
mark detection.
Read this Operation manual carefully and make the most effective use of your plotter.
Be sure to read this Operation manual carefully, before starting to operate the plotter.
This Operation manual to the models as firmware version 2.50 or later.
When turning on the power, you can confirm the firmware version. To confirm the firmware version
refer to "Turning the power on" (Refer to Page 2.7)
On This Operation manual
• This Operation manual describes the operation and maintenance of CG-FX series cutting
plotter (hereinafter referred to as the device).
• Please read and fully understand this Operation manual before putting the machine into
service. It is also necessary to keep this Operation manual on hand.
• Make arrangements to deliver this Operation manual to the person in charge of the op-
eration of this device.
• This Operation manual has been carefully prepared for your easy understanding, how-
ever, please do not hesitate to contact a distributor in your district or our office if you have
any inquiry.
• Description contained in this Operation manual are subject to change without notice for
improvement.
• In the case where this Operation manual should be illegible due to destruction or lost by
fire or breakage, purchase another copy of the Operation manual from our office.
To Next Page
Loading...
Need help?
General
