– 3.59 –
Switch the commands from a host computer [COMMAND]
Switch the commands according to the commands specifications from the host computer. Display
the recognized commands before starting to cut.
Setting value
AUTO : Switch automatically to MGL-I or MGL-IIc according to the received data commands.
MGL - Ic1: Use the value when receiving the MGL-I c1 commands data.
MGL-IIc : Use the value when receiving the MGL-II c commands data.
*When receiving a large data, the [AUTO] mode may not function normally. In
that case, change the command to the specific command, MGL - Ic1, or
MGL-IIc.
*When the value is set to [AUTO] in receiving a data from a computer, the
display panel indicates the recognized command before starting to cut. In
case the display panel continues to indicating the recognized command or
displaying the [ERR16 UTO I/F], the command cannot be recognized auto-
matically.
In the case, change the command to MGL-I c1 or the MGL- IIc to perform
cutting normally.
* The recognized command by the [AUTO] setting is effective until executing
the data clear (refer to 3.12) or pushing over the clamp lever.
To Next Page
Loading...
Need help?
General
