– 3.58 –
CT1
*
2KB
*
**
PLOT
**
5S
*
SORTING
*
1%
*
SORTING
*
10%
CT1
**
REMOTE
**
Sorting sequence
1. Data are being transmitted.
Unprocessed data size in the receiving buffer is displayed.
Cutting is not conducted. The processed line segments are
stored in the sorting buffer.
2. Data transmission completes.
Waiting time required to start cutting (Remaining time is
displayed in seconds)
If no data is received during the waiting time, the counter
starts counting down. The waiting time can be changed in
the [CLOSE TIME] of the communication conditions.
3. Auto-feed is executed.
Before starting cutting, the sheet is drawn by the length of
data to be cut. If the sheet is not long enough to cover the
whole data, the error shown below is displayed.
After changing to a long sheet, transmit data or execute
[No.COPIES]. ( Refer to Page 3.16)
4. Cutting starts.
Data that has been already cut is displayed in percents.
5. Cutting completes.
The plotter enters the remote mode.
• When the SORTING is set to the ON state, cutting will not start until the
specified close time has elapsed after receiving all pieces of data to be cut.
It should be noted, however, that received pieces of data are sorted and cut
in the following cases.
• When the sorting buffer is full of data. (Approximately 540000 line seg-
ments.)
• In case changing the Toll number, SPEED, PRESSURE, or cutting condition.
• When executing a feed command or origin change command
ERROR15 AUTOFEED
To Next Page
Loading...
Need help?
General
