– 2.18 –
4) Lock the roller stoppers.
Press the lock lever toward the rear from the front of the main
unit to lock them.
• The roll stoppers work to prevent the roll sheet
from turning when you draw out the rolled sheet.
5) Hold a sheet.
Draw the sheet to tense it.
Tilt the clamp lever away from you.
• In the case where the power to the device has been
turned on:
The suction fan will rotate to adhere the rolled sheet by suction.
• In the case where the power to the device has been
turned off:
The suction fan will not rotate.
It is, therefore, necessary to tilt the clamp lever away from
you while retaining the sheet with your left hand to prevent
the sheet from warping.
6) Release the roll stopper.
Draw the roll stopper toward you from the front side of the
main unit.
* If you don't release the roll stopper, the device
stop with buzzer during sheet feeding.
7) The display shown on the LCD changes.
Press the jogkey [ ] or [ ] to select [ROLL].
[
] : In the case where the roll sheet is loaded this side
[
] : In the case where the roll sheet is loaded far side
5) In case [ROLL. SELECT] is set [ON], select the
number of pinch roller to use.
Press the jogkey [ ] or [ ] to select.
6) Press the [ENTER/HOLD] key
The device detects the width and front end of the rolled sheet.
After giving the width of sheet on the LCD, the sheet will
conduct a dummy cut (see page 3.45) and displays the
currently specified tool conditions.
8)
Draw out the rolled sheet by the length to be used.
Press the [FEED] key to draw out the rolled sheet.
* Feed the paper before performing cutting
(plotting) to prevent from sheet slipping.
ROLL F LEAF
A =
****
B = 559
ROLL < R > LEAF
CT1 020 050 0.30
<
<
Release
Lock
PINCH ROLL . : 3
To Next Page
Loading...
Need help?
General
