– 3.23 –
* When setting the width between the pinch roller 1 and the pinch roller 3 as
the maximum width, the available automatic sheet cut range is as follows.
40mm from the inside of the pinch roller 1
80mm form the inside of the pinch roller 3
Setting value
Number of cutting sheet :1 to 999,999 sheets
Cut length :1 to 10,000 mm
Front cut off :0 to 30 mm
1 Make sure that the plotter is in local mode, and
then press the [FUNCTION] key.
2 Press the [ENTER/HOLD] key.
3 By pressing the jog key [
] or [ ], set the
number of times cutting is to be performed.
4 Press the [ENTER/HOLD] key.
5 Set the cut length (mm) by pressing the jog key
[
] or [ ].
6 Press the [ENTER/HOLD] key.
7 Set the front cut off length by pressing the jog
key [ ] or [ ].
8 Press the [ENTER/HOLD] key after completing
the settings.
The number of cut sheets is displayed while cutting operation
is being performed.
SHEET CUT <ENT>
COUNT = 100
COUNT = 1
SPACE = 1000 mm
SPACE = 000 mm
FRONT CUToff = 10
FRONT CUToff = 0
CN : 10 / 999999
FUNCTION
To Next Page
Loading...
Need help?
General
