– 3.36 –
Full-automatic detection of marks
It enables to compensate the difference in length of the registration marks between printed length
and detected length (A and B). For this purpose, measure the length A and B beforehand.
Measure the length between the registration marks.
Detect procedure ( [DIST.REVI.] Setting value is "BEFOR")
1) Measure lengths A and B contained in the data
to be output.
2) Place TP1 at a location as illustrated on the
left.
Cutting line depends on the tool in use.
• In the case where the “PEN” or “CUT” is specified in the
tool conditions: To the pen line rubber side
• In the case where the “PIN” or “HALF” is specified in the
tool conditions: To the pen line sponge side
• If it is impossible to place the registration TP1 at
the location given in the sketch, proceed to the
section describing “Semi-automatic registra-tion
mark detection.”
3) Taking care not to allow the sheet to slip out of
position, turn the clamp lever toward you.
Then, the pinch rollers will retain the sheet.
Mark: TYPE1 Mark: TYPE2
Mark: TYPE1
Mark: TYPE2
Approx. 5 mm
Roghtmost end of seal
Cutting line
Pinch roller
TP1
To Next Page
Loading...
Need help?
General
