Chapter 4 Cutting Function
4-12
Cutting MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• When you operate the machine according to the contents specified with the RIP software, set each item to “Host” when
registering this machine type. When you set it other than “Host”, the machine operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Description
TP DETECT ( P.4-5)
MARK DETECT
When you cut the data with register marks, you must set
without fail.
FORM
SIZE
OFFSET X
OFFSET Y
DETECT END KEY START
SENSOR LEVEL
MARK FILL UP
DETECT AREA
CUT MODE ( P.4-13) This is to set the cutting quality.
COPY ( P.4-13)
This function performs cutting for the received data on two or
more sheets.
Tool Change( P.2-24, P.2-24) You select this function when you replace the tool.
SETUP SUB MENU
UP SPEED ( P.4-15)
This is to set the speed of sheet and carriage movement when
the tool is up.
Setting the speed lower makes the sheet misalignment
reduced at the time of long sheet feeding.
DUMMY CUT ( P.4-15)
The blade edge is made to turn to a specific direction before
starting cutting, which allows dummy cutting.
SHEET TYPE ( P.4-15) This is to set the types of sheet according to the sheet you use.
ADJ PRS OFFSET ( P.4-15)
This is used to expand the value in such a case as when the
beginning and end part of the cut are left cut.
Vacuum fan
Set the strength of the vacuum fan at cutting.
Please use "weak" normally.
OVER CUT ( P.4-15)
By over lapping the start point and the end point arbitrarily, you
can make the media without uncut area.
Curve mode
If the cut line bends, set it to "SLOW".
Although the cutting speed decreases, it is possible to prevent
a bent.
RESET SETTING ( P.4-16) Reset the setting values to the initial state.
MAINTENANCE
MARK sensor ( P.4-17) This is for adjusting the register mark sensor.
SAMPLE CUT ( P.4-19)
In case that normal data cutting cannot be performed etc.,
perform cutting with the sample stored in this machine to find
out the cause of cutting error.
AUTO MEDIA CUT( P.4-19) Cutting a medium into multiple pieces with a certain length.
SCALE ADJUST( P.4-21)
When printing and cutting without register marks, adjustment is
performed if the misalignment in the scanning direction occurs
between the left and right edges of the media.
To Next Page
Loading...
