MIMAKI UCJV300-75 - Setting the Cutting Conditions; About the Cut Conditions

2-26
Chapter 2 Basic Operation
Setting the Cutting
Conditions
You can register the cutting speed and the pressure
depending on the sheet or the tool type to be used. (Cut
condition)
About the Cut Conditions
Items you can set here
About Selecting Cutting Condition
1
Press the key twice to display
"TOOL"
2
Press to display the cut condition.
• The three items shown in the following screen are
not displayed unless the half-cut is set to ON.
About half cutting
You can cut on the dotted line, not to cut sheet out. (Half
cut)
When you set half cut to valid (ON), you can use the half
cut function.
Tool condition
You can select the cutting condition No. (1
to 7) or plotting condition (PEN).
Cut speed Setting of the speed of cutting.
Cutting
pressure
Setting of the pressure (g) required for
cutting.
Offset
*1
*1. You cannot set this when "PEN" is selected in the tool condition,
Setting of the distance from the center of
the cutter holder to the cutter blade.
Half cut
*2
*2. The three items in the lower level are available when the half-cut is
set to ON.
Setting of enabling (ON)/disabling (OFF)
the half-cut function.
Half cut
press
Setting of the pressure of left part. (g)
H-leng
Setting of the length to be left (not to be
cut). (mm)
C-leng Setting of the length to be cut. (mm)
width:1340mm
PRTOOL
TEST CUT
LOCAL
• The illustration above is the image. The shape of
cut surface differs depending on the cutting condi-
tions.
CUTCONDITION
HALFCUTPRESSURE
80g
2.0mm H・LENG
20mm
C・LENG
>><<
CUTCONDITION
TOOL
CUT1
30cm/s SPEED
60g
PRESSURE
OFFSET
0.30mm
ON
HALFCUT
>><<
Cutter
Set the length to be
left (not to be cut).
Sheet
Set the length
to be cut.
Set the
cutting
pressure