MIMAKI UCJV300-75 - Setting a Roll Media

2-11
2
2
2
2
2
Chapter 2 Basic Operation
Setting a Roll Media
Attach a roll media to the roll media hanger located on the
back of the machine.
1
Confirm that the clamp lever is lowered.
2
Move the left roll holder to the roll setting
position.
• Loosen the roll holder fixing screw and move the
roll holder.
• Check the size of the media and where to set the
media by referring to the section applicable to
your machine (P.2-6).
3
Tighten the roll holder fixing screw on the
left side.
• Recheck steps 1 and 2.
4
Push the core of the roll media into the left
side of the roll holder.
• Push the roll media all the way into the roll holder
until it is held steady.
5
Loosen the screw at the right side of the
roll holder and insert the holder into the
core of the roll media.
6
Pull up the clamp lever located on the back
of the machine.
7
Insert the roll media into the machine.
• Slightly tilt the media so that it can be smoothly
inserted into the machine without catching on
anything.
(1) Pull the media all the way out to the front end
of the platen.
(2) Insert the media between the platen and the
pinch rollers.
• Pull the media out of the roll so that the
media can be grasped from the front of the
machine.
(3) Push down the clamp lever located on the
back of the machine.
• This holds the media in place.
• Be careful not to drop the media on your feet or
other part of your body while attaching it to the roll
media hanger. The media is heavy and can cause
bodily injury.
Roll holder side (the back of the machine)
This is where the end of the set
media should be when the media
has a 2-inch core.
This is where the end of the set media
should be when the media has a 3-inch core.
The reference position of the roll holder
must come between the pinch roller
guide marks.
• Set up the pinch roller unit such that the media is
held in place by equally-spaced pinch rollers. If the
pinch rollers holding the media in place are not
equally spaced, start over from step 1.
• Provide a dead space of at least 5 mm at both
ends of the media.