5-22
Chapter 5 Maintenance
Adjusting the Cutter Blade
After adjusting the blade edge, set the cut condition and
perform test cut to check whether cutting is performed
well.
1
Turn the adjusting knob to adjust the
protruding amount of the cutter.
• Turn the knob in the direction of the arrow to
extend the cutter blade.
( 0.5 mm per revolution)
Replacing cutters other than sup-
plied one
1
Loosen the lock nut, and pull the adjusting
knob out of the holder.
2
Insert the cutter into the adjusting knob.
• Use tweezers to insert the cutter into the adjusting
knob.
3
Tighten the lock nut.
Adjusting blade edge of cutters other
than supplied one
1
Loosen the lock nut.
2
Turn the adjusting knob to adjust the
protruding amount of the cutter blade.
3
Tighten the lock nut so that the adjusting
knob will not turn.
• The blade adjuster (Product No.: OPT-S1005) will
facilitate the adjustment of the protruding amount
of the blade.
To Next Page
Loading...
