MIMAKI UCJV300-75 - Setting the Scale Adjust

4-21
Chapter 4 Cutting Function
4
2
2
For Print & Cut with register marks
1
Set the machine to "REMOTE" status.
2
Set the print conditions (profile, cut conditions) of the job that you want to print using RasterLink.
3
Click [print & cut Origin adjust] in the [Cut edit] tab of RasterLink.
4
Select "Add register mark".
• Click [OK] to print the adjustment pattern.
5
When the pattern is printed, press
(ADJUST)
and select "TP OFFSET".
• When the media is fed, peal the cut part of the pattern, and check the adjustment values
(The actual pattern has register marks.)
6
Enter the adjustment values
• When you press the [ENTER] key, the media return, and the operation is completed.
Setting the Scale Adjust
When printing and cutting without register marks, adjustment is performed if the misalignment in the scanning direction
occurs between the left and right edges of the media.
When you perform scale adjustment, adjustment is performed automatically.
1
Set a media ( P.2-4)
• Set the sheet to print the register mark.
2
Press the (MENU) (>>) keys
• Cutting menu is displayed.
3
Press (<<)
4
Press to select “MAINTENANCE”, and press the [ENTER] key
5
Press to select "SCALE ADJUST", and press the key
6
Press the key on the confirmation screen
• A correction pattern is printed and correction is performed.
7
Press the key several times to end the setting
+ -
- +
X enlarged
Y enlarged
Enter the value of the position that has the
least misalignment between top and bottom
The example here shows that -4 has the least
misalignment, so enter “-0.40”.
Enter the value of the position that has the
least misalignment between right and left
The example here shows that 2 has the least
misalignment, so enter “0.20”.