MIMAKI UCJV300-75 - Setting of AUTO Power-Off; Setting of Take-Up Unit

3-14
Chapter 3 Machine Setting
Setting of AUTO Power-off
When no operation has been performed for the set
time, the power supply is automatically turned "OFF".
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press to select "AUTO POWER
OFF", and press the key.
3
Press to select a setting, and
press the key.
• Set Value: none, 10 to 600 min
4
Press the key several times to
end the setting.
Setting of Take-up Unit
Set the operation method when press the ON / OFF
button on the take-up unit.
1
In LOCAL mode, press
(MENU)
(twice
).
• The MACHINE SETUP MENU appears.
2
Press to select "TAKE-UP UNIT",
and press the key.
3
Press to select a setting, and
press the key.
• Set Value: ON/ OFF
4
Press to select "TAKE-UP SW",
and press the key.
5
Press to select a setting,
and press the key.
• Set Value: Continuance/ Temporary
Continuance:Switching ON / OFF the winding
operation when pressing the switch
each time. (Take-up unit in
operation does not stop until press
again ON / OFF switch.)
Temporary: Do the winding operation only while
holding down the switch. (When
release the switch, winding
operation is stopped. )
6
Press the key several times to
end the setting.
EVENT MAIL
Message
Subject
(P.3-19)
Set the characters to write in
the subject of the event mail.
Alphanumeric characters and symbols (within 8 characters)
Server Setup
(P.3-19)
SMTP Address Set the SMTP server.
SMTP Port No. Set an SMTP port number.
SENDER ADDRESS Set the e-mail address to be used as the sender mail address.
Authentication
OFF
Set the SMTP server authentication method (SMTP
authentication).
POP before
SMTP
SMTP
Authentication
User Name
*2
Set the user name used for the authentication.
Password
*2
Set the password used for the authentication.
POP3 Address
*3
Set the POP server.
APOP
*3
Set ON/ OFF of APOP.
Transmit Test
(P.3-21)
Send the test e-mail.
RESET ( P.3-22) All setting values are returned to the status default.
*1. Settable when both of DHCP and AutoIP are [OFF]
*2. Settable only when Auth. is not OFF
*3. Settable only when Auth. is POP before SMTP
Function name Set value Default Meaning