2-3
2
2
2
2
2
Chapter 2 Basic Operation
Turning the Power On/
Off
Turning the Power On
This machine has two power switches.
Main power switch:
This switch is located on the side of the machine. This
switch must always be on.
[END/POWER] button:
Normally, use this button to turn the power on or off. As
long as the main power switch is on, the machine
periodically turns on to activate the function that
prevents ink sedimentation, even when the [END/
POWER] button is turned off.
1
Turn the main power switch on.
• Press the main power switch located on the side
of the machine to the "I" position.
• The firmware version is displayed when the power
is turned on, and the initial operation begins.
2
Press the button to turn the
power on.
• The machine enters LOCAL mode.
3
Turn on the computer connected with the
machine.
Turning the Power Off
After using the printer, press the [END/POWER] key to
turn off the power.
Before turning the power off, confirm the following:
• If the machine is receiving data from the computer or if
there is any data that has not been output yet
• If the head has returned to the capping station
• If any error has occurred ( P.6-7Error messages
)
1
Turn off the computer connected with the
machine.
2
Hold down the button to turn
the power off.
• Do not turn off the main power switch on the side
of the machine.
• The next time you use this machine, just press the
[END/POWER] button.
Precautions on turning the power off
Do not turn the main power switch off.
As long as the main power switch is on, the machine
periodically turns on to activate the function that
prevents ink sedimentation.
When the main power switch is off, this function does
not work, which can cause nozzle clogging.
Keep the front cover and the maintenance
cover closed.
When these covers are open, the function that
prevents ink sedimentation does not work.
Check the position of the head, and then turn
the power off.
If you turn the power off without the head returned to
the capping station, the ink head dries up, causing the
nozzles to become clogged.
Thus, if you have turned the power off without the
head returned to the capping station, turn the power
on again, confirm that the head has returned to the
capping station, and then turn the power off.
Do not turn the power off during printing or
cutting.
If you do so, the head might not return to the capping
station.
Press the [END/POWER] button to turn off the
power, and then turn the main power switch
off.
If you have to turn the main power switch off to move
the machine or to resolve an error that has occurred
on the machine, first hold down the [END/POWER]
button on the front of the machine, confirm that the
display on the operation panel has turned off, and then
turn the main power switch off.
• Close the front cover and the maintenance cover
before turning the power on.
• Leaving the machine with the main power switch
turned off for a prolonged period of time can cause
the head nozzles to clog.
Main power
switch
[END/POWER]
button
To Next Page
Loading...
