1-17
Chapter 1 Before Use
1
2
2
2
2
Media
This section describes the size of media that can be used with this machine and how to handle it.
The Size of Media That Can Be Used with This Machine
Precautions on Handling the Media
Observe the following precautions for handling the media:
Model UCJV300/150-160 UCJV300-130 UCJV300-107 UCJV300-75
Type of recommended media
Label stock (paper-based) / PVC sheet (including laminated sheet, 0.25 mm thick maximum) /
reflective sheet (excluding high-luminance reflective sheet) / heat transfer rubber sheet
Maximum width 1620mm (63.8in) 1371mm (54.0in) 1100mm (43.3in) 810mm (31.9in)
Minimum width 210mm (8.3in)
Maximum print width 1610mm (63.4in)
*1
*1. When the MARGIN(RIGHT/LEFT) setting has been set to the minimum (-10 mm).
1361mm (53.6in)
*1
1090mm (42.9in)
*1
800mm (31.5in)
*1
Roll media
Thickness 1.0 mm (0.04in) maximum
Roll outside diameter
Paper media: Φ250mm (9.8in) maximum
Other media: Φ210mm (8.3in) maximum
Roll weight 40 kg (88.2lb) maximum
Roll inside diameter 2 or 3 inches
The side to be printed Inside/outside
Roll end treatment The roll end is gently fixed to the core with weak-adhesive tape or weak glue for easy removal.
• Use the recommended media.
Use the media recommended by MIMAKI to ensure reliable, high-quality printing.
• Note that the media can shrink or stretch.
Do not use media immediately after unpacking. The media can shrink or stretch due to room temperature and humidity.
After unpacking the media, leave it in the place where the media is to be used for at least 30 minutes before installing it in
the machine.
• Do not use curled media.
Using curled media can cause paper jamming. When rolling regular-sized coated media for storage, make sure that the
coated side is facing outward.
• Dust may be accumulated on the edge of the media.
Depending on the roll you are using, the dust inside the package may be gathered on the edge surface of the roll. Using
dusty media can cause nozzle missing or ink drops that can lead to degraded printing quality. Remember to remove the
dust on the edge surface of the roll before installing it on the machine.
To Next Page
Loading...
