5-8
Chapter 5 Maintenance
4
Open the left maintenance cover.
5
Remove the mist filter.
• Mist filters are located in two places.
• To remove the mist filter, pull the knob to the front
while pushing the hook in the direction indicated
by the arrow.
6
Clean the filter.
• Remove the filter, and remove the stain by holding
paper towel or the like.
• Wipe off any stain adhering to the filter case.
7
Set the mist filter at the original position.
8
Close the maintenance cover, and press
the key.
• After its initial operation, the machine returns to
LOCAL.
Clean the NCU
Ink and dust adhere to NCU.
If ink or dust adheres, normal operation may not be
possible.
1
Press the (MENU)
and press the key in local.
• Display maintenance menu.
2
Press to select "Station
Maintenance" and press the key.
3
Press to select "Carriage Out"
and press the key.
4
Press to select "STATION
MAINT." and press the key.
• The carriage moves over the platen.
5
Open the front cover.
6
Include maintenance cleaning solution on
clean stick (SPC-0421) and wipe off ink and
dust adhered to NCU.
7
Press the key after the cleaning.
8
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
step 1.
• If the stain strongly attached to the filter, such as
the liquefaction of the ink attached to the filter,
please replace the filter (SPC-0819).( P.5-19)
Maintenance cover
Maintenance cover
To Next Page
Loading...
