5-9
5
2
Chapter 5 Maintenance
Washing the Head Nozzle
1
Press the
(MENU)
and press the key.
• MAINTENANCE MENU will be displayed.
2
Press to select "STATION",
and press the key.
3
Press to select “NOZZLE WASH”,
and press the key.
• The carriage moves onto the platen.
4
Clean the wiper and the bracket, and press
the key.
(1) Open the front cover then pull out it by
holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in cleaning solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Clean the cap rubber , and press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
6
Fill up the cap with cleaning solution for
maintenance.
• Suck cleaning solution into a dropper and fill up
the cap with it. Fill up the cap with cleaning
solution on the verge of overflow from the cap.
7
Close the front cover, and press the
key.
8
Press the key.
• The maintenance washing liquid filled in the cap is
absorbed.
• “Please Wait” will be displayed in the display until
the time you set has elapsed.
• It takes about one minute for NOZZLE WASH.
Cleaning of ink discharge passage
In order to prevent clogging of ink due to coagulation of
ink inside the ink discharge passage, clean the ink
discharge passage periodically (once a week).
1
Press the
(MENU)
and
press the key.
• MAINTENANCE MENU will be displayed.
2
Press to select "STATION", and
press the key.
3
Press to select "DISWAY WASH",
and press the key.
• The carriage moves onto the platen.
• When nozzle missing is not cleared even after this
washing is carried out several times, contact our
service desk or your local distributor for service.
To Next Page
Loading...
