5-19
5
2
Chapter 5 Maintenance
5
Remove the mist filter.
• Mist filters are located in two places.
• To remove the mist filter, pull the knob to the front
while pushing the hook in the direction indicated
by the arrow.
6
Replace with a new filter (SPC-0819).
7
Insert the mist filter.
8
Close the maintenance cover, and press
the key.
• After its initial operation, the machine returns to
LOCAL.
If a Waste Ink Tank Confirmation
Message Appears
Ink that is used for head cleaning is collected in the waste
ink tank on the bottom right side of this machine. This
machine keeps track of the total volume of ink that is
discharged, and displays a confirmation message when a
certain volume is reached. (When this message is
displayed, consider the replacement of the waste ink
tank.)
Confirmation Message in LOCAL
1
The warning message "Check waste
ink"appears on the display.
2
Check the state of the waste ink tank.
• If the actual volume is not displayed correctly,
perform the operation in Step 3.
• If the actual volume is displayed correctly, replace
the waste ink tank.
When you replace (dispose of) the waste tank ink,
perform the procedure in "Replace the waste ink
tank with another". ( P.5-19)
3
Press the
(MENU)
and
press the key.
• MAINTENANCE MENU will be displayed.
4
Press to select "INK TANK
EXCHANGE", and press the key.
5
If the waste ink amount needs to be
adjusted, press to adjust the
level, and then press the key.
Replace the waste ink tank with
another
If the waste ink tank becomes full, use the following
procedure to replace the waste ink tank with another, and
set the waste ink information in the maintenance menu to
0%.
If you replace the waste ink tank before the waste ink tank
confirmation message is displayed (before the 2L tank is
80% (1.6L) full, use the same procedure to replace the
waste ink tank.
1
Press the
(MENU)
and
press the key.
• MAINTENANCE MENU will be displayed.
2
Press to select "INK TANK
EXCHANGE", and press the key.
• Waste ink tank information is displayed.
3
Press to adjust the level, and
press the key.
• The waste ink tank amount that is managed in this
machine will be reset.
4
Open the waste ink tank cover.
5
Pull it frontward to remove by holding the
waste ink tank handle.
• The message is displayed when it reaches 80%
(1.6L) of the 2L tank.
To Next Page
Loading...
