MIMAKI UCJV300-75 - Setting of Left and Right Margins; Setting of Vacuum Fan; Setting of Feed Speed

3-8
Chapter3 Setup
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15 mm is set
hereupon.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4, and
press the key.
• The setup menu appears.
3
Press
(>>)
.
4
Press to select "Margin/L" or
"Margin/R", and press the key.
5
Press to select a set value, and
press the key.
• Set value: HOST/-10 to 85 mm
6
Press the key several times to
end the setting.
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• The setup menu appears.
3
Press
(>>)
.
4
Press to select "VACUUM FAN",
and press the key.
5
Press to select a set value, and
press the key.
• Set value: HOST/WEAK/STANDARD/STRONG
6
Press the key several times to
end the setting.
Setting of Feed Speed
Changes the media feeding speed in printing.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4, and
press the key.
• The setup menu appears.
3
Press
(>>)
.
4
Press to select "FEED SPEED",
and press the key.
5
Press to select a set value, and
press the key.
• Set value: HOST/10% to 200%
6
Press the key several times to
end the setting.
• When you give priority to the setting at the RIP
software side, make the setting value "Host".
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the Ras-
terLink, if you set this machine to "Host", printing
will be performed in "Margins for right and left off
set value= 0 mm" status.
• The margin setting is reflected when the media
width is detected.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in print-
ing.
• Depending on the print conditions, some settings
might not be applied (that is, the feeding speed
might remain the same).