5-20
Chapter 5 Maintenance
6
Replace the waste ink tank.
(1) Prepare a new waste ink tank (SPC-0117) or
discard waste ink from current waste ink
tank.
(2) Insert the waste ink tank by holding a handle
of the tank.
7
Close the waste ink tank cover.
8
Press the key.
• The ink discharging amount that is controlled by
the machine is reset and the message is
canceled.
Replacing the waste ink tank before the waste
ink tank confirmation message is displayed
If you replace the waste ink tank before the waste ink tank
confirmation message is displayed (before the 2.0L tank
is 80% (1.6L) full, use the same procedure in the previous
section.
1
Perform steps 3 through 8 in "Replace the
waste ink tank with another" ( P.5-19)
to empty the waste ink tank.
Replacing the Cutter Blade
The media cutter blade is consumable. When the cutter
blade gets dull, replace it with a new one (SPA-0107).
1
Press the
(MENU)
and
press the key.
• Cutting menu is displayed.
2
Press to select “TOOL
CHANGE”, and then press the
key.
• The cutter unit moves.
• Put a cap on the waste
ink tank removed.
• Waste ink is equivalent to waste oil of industrial
waste. Request an industrial waste disposal com-
pany for disposal of waste ink.
• The blade is sharp. Be careful not to hurt yourself
or anyone else.
• Store the cutter blade in a place that is out of the
reach of children. In addition, dispose of used cut-
ter blades according to regional laws and regula-
tions.
• When replacing the cutter blade, it is recom-
mended to place a sheet of paper under the cutter
blade. This will help pick up the cutter blade if it
drops.
To Next Page
Loading...
