2-10
Chapter 2 Basic Operation
Maximum Print/Cut Area
The maximum printable area or cut area varies, depending on the position of the media width ( P.2-6) and the origin
position ( P.2-16).
The area other than that is the dead space that cannot be printed/cut.
Precautions on Setting the Media
Setting position of the media
Set the media such that the right end of the media lies within the area shown in the following figure:
The end of the media should not lie beyond the slit line on the platen.
UCJV300/150-160 UCJV300-130 UCJV300-107 UCJV300-75
Maximum printing/cut width 1610mm (63.4in) 1361mm (53.6in) 1090mm (41.7in) 800mm (31.5in)
Set the media such that the right end of the media lies within the
area indicated by the arrows (within the first three grit rollers
from the right end on the front of the machine).
Media
Media press
Slit line
To Next Page
Loading...
