3-3
3
2
2
2
Chapter3 Setup
SETUP MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• When you operate the machine according to the contents specified with the RIP software, set each item to "Host" when
registering this machine type. When you set it other than "Host", the machine operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set Value
*1
*1. The underlined values above represent the default settings.
When no
instruction
from RIP
exists
*2
*2. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority to the setting value at the
machine side.
Description
FEED COMP. ( P.3-5) -9999 to 0 to 9999
Used to print a pattern for correcting a media-
feeding rate and correct it.
DROP.POScorrect ( P.3-6) -40.0 to 0
to 40.0
Used to adjust the dot position in go and return
printing.
LOGICAL SEEK ( P.3-7) HOST
/ON / OFF OFF Sets the scan movable area during printing.
OVER PRINT ( P.3-7) HOST
/ 1~9 times 1 time Set the number of times of overprinting of ink.
DRYING TIME
(P.3-7)
SCAN HOST/0.0 to 9.9 sec 0 sec Sets the time to wait for ink drying.
PRINT END HOST
/0 to 120 min 0 min Sets the ink drying time after printing.
MARGIN/LEFT ( P.3-8)
HOST
/-10 to 85 mm
0 mm
Sets a non-printing area along the right and left
edges of the media.
MARGIN/RIGHT ( P.3-8 0 mm
VACUUM FAN ( P.3-8)
HOST
/ WEAK/ STANDARD/
STRONG
STRONG Sets the absorbability of the media.
FEED SPEED
*3
(P.3-8)
*3. When you set this to "100%" or more, required time for completion of printing will be shortened. However, enough drying time cannot be ensured and it may
affect the image quality.
*4. Displayed when the optional ionizer is connected.
HOST/10 to 100 to 200％
100 % Changes the media feeding speed in printing.
AUTO
CLEANING
(P.3-9)
OFF, FILE,
LENGTH, TIME
Sets the automatic cleaning operation for the
head performed before printing or during printing.
FILE
INTERVAL 1 to 1000
TYPE NORMAL/ SOFT/ HARD
LENGTH
INTERVAL 0.1 to 100.0 m
TYPE NORMAL/ SOFT/ HARD
TIME
INTERVAL 10 to 120 min
TYPE NORMAL/ SOFT/ HARD
Cleaning Check ON/ OFF
Sets whether to perform a nozzle check after
automatic cleaning.
INTERVAL WIPING ( P.3-10) 3 to 255 min, OFF
Sets the wiping operation performed during
printing.
MAPS
(P.3-9)
AUTO
Change the effect of "MAPS".
MANUAL
Smoothing
level
0 to 100%
Speed
50 to 100%
Expansion
ON/ OFF
UV mode ( P.3-10) ON / OFF / No printing ON Specify UV irradiation during printing.
Ionizer
*4
( P.3-10) ON / OFF Set the operation of the ionizer (option).
LT mode ( P.3-11) ON / OFF OFF
Set LT mode when you need more flexibility than
the default UV mode print.
RESET SETTING ( P.3-5) The configuration in the settings 1-4 can be reset individually.
To Next Page
Loading...
