EasyManua.ls Logo

MIMAKI UCJV300-75 - Ink Filling; Air Purge

MIMAKI UCJV300-75
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-16
Chapter 5 Maintenance
INK FILLING
Supplies ink to correct nozzle clogging.
1
Press the
(MENU)
and
press the key.
MAINTENANCE MENU will be displayed.
2
Press to select "FILL UP INK",
and press the key.
3
Press to select the filling head,
and press the key.
4
Press the key.
Ink is supplied automatically.
5
Press the key several times to
end the setting.
AIR PURGE
For discharging ink and air that is in the head out of a port.
Use this function if ink colors become mixed inside a
head, or if air causes a nozzle to clog.
1
Press the
(MENU)
and
key in LOCAL.
Maintenance menu will be displayed.
2
Press to select "AIR PURGE",
and press the key.
3
Press to select the head to air
purge and check with .
Checked head is the target head to be air purged.
From the table below, select the head with the
color (port) to be purged. (Head 1 only for
UCJV150 Series)
For UCJV300 Series, Head 1 and Head 2 can be
selected at the same time. Select both Head 1
and Head 2 when the ink set is 4 colors.
4
Press the key to move the
selection head onto the wiper.
5
Open the front cover.
6
Open the lid on the front of the carriage.
Remove the screws and slowly lower the lid.
7
Remove the cap of the target port.
The layout of the port is as shown below.
Turn the cap about 30 ° counterclockwise and
then remove it.
The removed cap has ink attached. Temporarily
put on paper towels etc. so as not to contaminate
the surroundings.
Air purge is done for each head.
Do not remove the cap of Head 2 when removing
air of Head 1.
Tools required for cleaning
Gloves Safety glasses
Paper towel
Be sure to wear the attached safety glasses and
gloves when cleaning the area around the ink
head. Otherwise, you may get ink in your eyes.
If you get ink in your eyes, immediately wash your
eyes thoroughly with a lot of clean water for at
least 15 minutes. Then, consult a doctor as soon
as possible.
If the ink adheres to your skin, use a large amount
of water and soap or special detergent for skin to
remove the ink.
Ink set Head 1 Head 2
4 colors CMYKYKMC
6 colors+W C M Y K Lm Lc W W
4 colors+CL+W C M Y K CL CL W W
4 colors+W C C M M Y K W W
Head 1 Head 2
UCJV300 Series
4 colors
CMYK YKMC
UCJV300 Series
6 colors + W
CMYK LmLcWW
UCJV300 Series
4 colors + CL + W
CMYK CLCLWW
UCJV300 Series
4 colors + W
CCMM YKWW
UCJV150 Series
4 colorsCMYK
Ink set Head 1 Head 2
ScrewLid
CY
MK
YM
KC
CY
MK
Lm W
Lc W
CY
MK
CL W
CL W
C M
CM
YW
KW
CY
MK

Table of Contents

Related product manuals