3-6
Chapter3 Setup
8
Press the key several times to
end the setting.
Correcting media-feeding during
printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
1
Press the
(ADJUST)
key in
remote mode.
2
Press , and then enter a media-
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the
corrected feeding rate soon.
3
Press the key twice.
• The changed value is registered.
If the Positions of Dots Shift...
When the condition for printing (media thickness/ink type/
etc.) has been changed, perform the following operation
to correct the ink drop position for bidirectional (Bi)
printing and obtain the proper printing result.
Example of a printed pattern
1
Set a media on the machine. ( P.2-4)
• In order to print a pattern, media that is at least
500 mm wide is necessary.
2
Press the
(MENU)
key in
LOCAL.
3
Press to select SETUP 1 to 4, and
press the key.
• The setup menu appears.
4
Press to select
"DROP.POScorrect", and press the
key.
5
Press the key.
• Printing of the Drop position correct printed
pattern will start.
• Multiple test patterns are printed. (The printed
patterns are called Pattern 1, Pattern 2, Pattern
3... in the order of printing.)
6
Press to enter a correction value
of Pattern 1, and press the key.
• Corrected feeding rate: -40 to 40
• Check the test patterns. The position where an
outward feeding line and a return feeding line
become one straight line is the correction value.
• When the correction value in not between -40 and
40, adjust the height of the printing heads and
perform the operations in Step 2 and later.
7
In the same way as in Step 4, enter a
correction value of Pattern 2 and later, and
press the key.
8
Press the key several times to
end the setting.
The dots at the fourth position
counted from the zero position in
the positive direction form a
straight line.
Output
To Next Page
Loading...
