Chapter 6 Troubleshooting
6-4
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Measures
Operation cannot be performed because
no media is detected.
• Execute after media is detected.
The motor is OFF after the cover was
opened etc.
• Return to LOCAL and execute the operation
after completion of initialization.
An ink error occurred.
• Execute the operation after replacing with a
new ink bottle.
The front cover or the maintenance
cover is opened.
• Execute the operation after closing the
cover.
Data was received.
• Execute the operation after executing data
clear.
Message Cause Measures
The waste ink tank count has exceeded
the prescribed amount.
• Check the amount of waste ink in the waste
ink tank.
• Conduct maintenance and waste ink tank
replacement, and reset the amount of waste
ink.
The used count of wiper has exceeded
the prescribed number.
• Execute maintenance, station maintenance
and wiper exchange and replace the wiper.
No media is set. Or, the sensor is faulty.
• Set the media.
If the same error message still appears after
setting the media, contact your local
distributor, our sales office, or service center.
Print data is received in LOCAL.
• Shift to REMOTE and execute printing.
Or, execute data clear and cancel printing.
Temperature in the installed environment
(machine) is too high.
Stable printing cannot be done.
• Adjust the ambient temperature to within the
specified scope (20 ℃ to 35 ℃ ).
Temperature in the installed environment
(machine) is too low.
Stable printing cannot be done.
The NCU unit is not connected.
The nozzle check function cannot be
used.
• Turn off the power on the machine and turn it
on after a while.
When displaying again, contact your local
distributor, our sales office, or service center.
INVALID OPERATION
MEDIA UNDETECT
INVALID OPERATION
MOTOR POWER OFF
INVALID OPERATION
INK ERROR
INVALID OPERATION
COVER OPEN
INVALID OPERATION
DATA REMAIN
To Next Page
Loading...
