2-15
2
2
2
2
2
Chapter 2 Basic Operation
Setting Leaf Media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Raise the clamp lever.
2
Insert the leaf media between the platen
and the pinch rollers.
3
To print, hold the media with the media
press gently.
• When using thick media, remove the media press
from the media before printing.
• You do not have to use the media press to cut the
media.
4
Push down the clamp lever.
• Set the media straight.
5
Press the key.
6
Press and select "LEAF".
7
The media detection is started.
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.
• Set up the pinch rollers such that the media is held
in place by equally-spaced pinch rollers. If the
pinch rollers holding the media in place are not
equally spaced, start over from step 2.
• Provide a dead space of at least 5 mm at both
ends of the media.
• The media must lie on the black part of the "after
cover", with at least 40 mm of the media lying off
the edge of the black part. If it is shorter than that,
it may not be able to perform the media detection.
• After setting the media in place, set the pinch roller
pressure, referring to P.2-13 "Setting the Pinch
Roller Pressure".
Media
Approximately 40 mm
After Cover
To Next Page
Loading...
