MIMAKI UCJV300-75 - Select the Tool Condition; Set the Cut Conditions

2-27
2
2
2
2
2
Chapter 2 Basic Operation
Select the Tool Condition
Before cutting (plotting), select the tool condition
depending on the sheet and the tool type to be used.
1
Press the key twice to display the
"TOOL" menu.
2
Press the (TOOL).
3
Press the key.
4
Press to select a tool condition
to be used.
• Each time you press [][], the tool condition is
switched as follows.
5
Cutting. ( P.2-29)
Set the Cut Conditions
Set the condition to cut or to plot with a pen.
Setting contents of cutting condition (CUT1 to 7):
Cut speed (SPEED)/ cut pressure (PRESS)/ OFFSET
value/ Half cut
Setting contents of plotting condition (PEN):
Plotting speed (SPEED)/ pen pressure (PRESS)
1
Press the key twice to display the
"TOOL" menu.
2
Press the (TOOL).
3
Press the key, Select a tool
condition to be used by using ,
and then press the key.
4
Press to move the cursor to cutting
speed, and press the key.
5
Press to set the cutting speed,
and press the key.
• Set the moving speed of the tool for cutting or pen
plotting.
• Setting values: 1 to 10 cm/s (settable by 1cm/s
step)
15 to 30 cm/s (settable by 5cm/s
step)
6
Press to move the cursor to cutting
pressure,and press the key.
7
Press to set the cutting pressure,
and press the key.
• Set the pressure that the tool presses the sheet
for cutting or pen plotting.
• Setting values: 10 to 20 g (settable by 2 g step)
25 to 100 g (settable by 5 g step)
110 to 450 g (settable by 10 g
step)
8
Press to move the cursor to OFFSET,
and press the key.
9
Press to set the offset value, and
press the key.
• When you set the cutting condition (CUT1 to 7),
set the distance between the center of the cutter
holder and the blade tip.
• Setting values: to 250 (0.00 to 2.50 mm)
(settable by 0.05 mm step)
10
Press to move the cursor to half cut,
and press the key.
11
Press to set ON/OFF, and press
the key.
• When you perform half cut, select ON and
proceed to the Step 11.
• When you are not performing half cut, select
"OFF" and proceed to Step 18.
12
Press to move the cursor to pressure
setting of left part (not to be cut), and
press the key.
13
Press to set pressure, and press
the key.
• Set the pressure of the left part (not to be cut)
when performing half cut.
• Setting values: 0 to 300 g (settable by 5 g step)
14
Press to move the cursor to the
setting of length to be left, and press the
key.
15
Press to move the cursor to the
setting of length to be left, and press the
key.
• Set the length to be left not to be cut when
performing half cut.
• Setting values: 0.1 to 5 mm (settable by 0.1 mm
step)
CUT1 ～ 3
PEN
CUT4 ～ 7
• When the cutting (plotting) pressure setting is
completed, proceed to the setting of the OFFSET
value. When you set the plotting condition (PEN),
you cannot set the OFFSET value and half cut.
Proceed to the Step 16.
• The maximum pressure at selecting PEN is 150 g.
Cutter
holder
OFFSET
Blade